WXL2-S Wireless LCD Screen Display, Two Sensors Car Backup System
Item Price: $55.00
Wireless LCD screen with backlit light shows the distance. No need to layout the wires to connect the display unit. You can choose the stick-on style sensors to make the installation easy. No need to drill holes The system sensors transmit a modulated
beam signal which is capable of seeing through fog, rain,
smoke, and snow..day or night. Warning Distance:15" - 90"
(Shipping & handling will be calculated based on the shipping zip code)
Step 1: Connect the Electric Power
Step 2: Install the Stick-On Sensors on the Bumper
Open the trunk, on the back of the blanket, find the wires to the back light housing.
Use of a 12 volt multi-meter, Probe the appropriate wiring harness which
heads toward the reverse light connector of the vehicle, looking for the wire
which carries 12 volts + when reverse gear is engaged, and no voltage when
reverse gear is disengaged. Never use a test light to probe wires.
Once you have located the proper reverse light power wire, use a quick
connector (included) to connect the RED wire from the control processer. You do
not need to cut any wire.
Stick the sensors on the bumper, or somewhere can be easy to run the wires of sensors into the trunk.
Find the place where the wires of sensors can be easy run into the trunk,
such as the hole of rain water pipe, etc.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.
Insert the ciagrette power plug of the display unit into the ciagrette power
hole of the car, and test the system.
Wireless LCD screen with backlit light shows the distance.
