Digital Read-Out, Backup Two Sensors System (CE0010)
Two ultrasonic sensors mount on your bumper with plugs to the control module which snaps in. Digital and Cursor shows the distance range. The system alerts with a variable multitone audio pulse and panel display. The system sensors transmit a modulated beam signal
which is capable of seeing through fog, rain, smoke, and snow day or night. The device is only activated when the driver puts their vehicle into reverse.
Item Price: $25.00 (Shipping & handling will be calculated based on the shipping zip code)
Specification
Number of Sensors
2
Sensor's Size
20mm
Include Drilling Bit
Yes
Detecting Distance
118"-11.8"
Display Unit Size
3.5" x 1" x 0.5"
Alarm Beeping
Inside the display unit
Display Unit Wire Length
20 feet
Rear Sensors' Wire Length
8 feet
Step 1: Connect the Electric Power
Step 2: Install the Backup Sensors for
Insert-In Style
Stick-on Style
Open the trunk, on the back of the blanket, find the wires to the back light housing.
Use of a 12 volt multi-meter, Probe the appropriate wiring harness which
heads toward the reverse light connector of the vehicle, looking for the wire
which carries 12 volts + when reverse gear is engaged, and no voltage when
reverse gear is disengaged. Never use a test light to probe wires.
Once you have located the proper reverse light power wire, use a quick
connector (included) to connect the RED wire from the control processer. You do
not need to cut any wire.
Drill two holes through the license plate and the trunk.
Install two insert-style sensors with the special housings on the license plate as the picture shown.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.
test the system.
(Note: The license plate holders are available for the two sensors version of the backup sensors system. They are
free of charge. If you need them, please write a request on the comment field when place an order.)
OR
Drill two or four holes in the bumper via provided drilling bit.
Install the insert-style sensors in the bumper.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.
Stick the sensors on the bumper, or somewhere can be easy to run the wires of sensors into the trunk.
Find the place where the wires of sensors can be easy run into the trunk,
such as the hole of rain water pipe, etc.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.
Insert the ciagrette power plug of the display unit into the ciagrette power
hole of the car, and test the system.
Two ultrasonic sensors mount on your bumper with plugs to the control module which snaps in.
